How to Install Engineered Wood Floor over Tiles

Last Updated on

The engineered wood flooring is generally sold as “floating” flooring that means it isn’t nailed or glued to the subfloor in any way. So, the boards simply snap together tightly to form the floor’s surface, and it will sits on a layer of foam underlayment. That’s why, it have a great advantages over traditional wood flooring. You can install engineered wood floor over any flat, solid surface, including a tile floor.

How to Install Engineered Wood Floor Over Tiles

Materials Required

  • Hammer
  • Pry bar
  • Plastic foam underlayment
  • Razor knife
  • Engineered wood floating flooring
  • Wall spacers
  • Tape measure
  • Miter saw
  • Table saw
  • Trim nails

Install Engineered Wood Floor Procedure

  1. Remove the floor trim from around the perimeter of the room using your pry bar and hammer. Keep it intact as you remove it. Set it aside.
  2. Roll out a course of plastic foam underlayment on top off the tile, on the edge of the room where you want to start. Use your razor knife to cut the strip to size.
  3. Lock two engineered wood floating floorboards to each other at their ends, snapping them as instructed systems vary. Set them at one end of the floor, on the underlayment. Put spacers between the wall and the board to keep them slightly out from the wall.
  4. Set additional boards along the wall end to end, putting spacers alongside all of them. Use a miter saw to cut the last board as needed.
  5. Lay the second course alongside the first, locking the boards in place by the fittings on their long sides. Set the boards in varied sizes so the ends are staggered between courses.
  6. Build across the floor course by course, laying out additional underlayment as necessary. Continue staggering the boards from course to course and cutting the final board of each course as necessary.
  7. Cut the last final course along their lengths on a table saw so they fit along the ending wall, leaving a 3/8 inch space at the wall.
  8. Re-install the trim with your hammer and trim nails. The trim will hide the gaps around the edges of the floor. You can also use flooring nailer to install engineered wood floor in this case.

Finally

We hope that you have learned a lot about the engineered hardwood flooring and the process to install it over tiles.

 

Rate this post

Speak Your Mind

*

0 Shares
Share
Tweet
+1
Pin
Share